Waterjet cutting is called water knife.It is a technology from the United States, this technology was first used in the aerospace industry.As times change and technology advances, the waterjet has entered into our daily production, water jets are widely used in ceramics, stone, glass and other industries. Now we begin to introduce its important parts:nozzles.
Nozzle:
Q:What are the waterjet part nozzles' specifications?
A: Conventional standards are as follows
6.00-1.02-76.2
6.00-0.76-76.2
6.35-1.02-76.2
6.35-0.76-76.2
7.00-1.02-76.2
7.00-0.76-76.2
7.14-1.02-76.2/101.6
7.14-0.76-76.2/101.6
8.00-1.02-76.2/101.6
8.00-0.76-76.2/101.6
9.45-1.02-76.2/101.6
9.45-0.76-76.2/101.6
Q: How do I install nozzles correctly?
A: First, we need to ensure that gem nozzle seat and mixed sand tube working level is no dust jacket, high cleanliness; then, you can test the water column to be straight, this test is for gem mouth device, and then mixed with sand tubes good; then, the need for the low-pressure sand-free water testing, to test the final requirement to be met is straight jet of water must be present no scattering, in order to ensure the tube after mixed sand and gem absolutely concentric nozzle can competence Gaza with normal pressure cutting; and finally, it should be mixed with sand to protect the tube rotation angle of 120 degrees, when you have to use mixed sand tube 10-20 hours, it should be sand tube rotate 120 degrees, so you can ensure a greater degree of sand control of life .
Q:What affect nozzle's life?
A: Influence Waterjet Parts - nozzles' life, there are many factors, such as precious stones and the best ratio of the inner diameter of the nozzle mixed sand tube diameter, a size and quality of sand, whether through full filtered water. The most important factors or concentricity jewel orifice tube and mixed with sand.
TEL：+86-021-69787273
sales@zgwaterjet.com
2936776793
Introduction of Water Jet Parts Nozzle
